ENGINE MISFIRE 2003-2004 Mustang, 1999-2004 Navigator 2002-2003 Blackwood...
download Some 1999-2004 Navigator, 2002-2003 Blackwood, 2003-2005 Aviator, 2003-2004 Marauder and 2003-2004 Mustang vehicles built before 12/19/2004 equipped with 4.6L 4V/5.4 4V engine may exhibit a...
View Article1996 Ford Aerostar/Ranger/Explorer Camshaft Position (CMP) Sensor REMOVAL AND...
download CAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) or T96T-12200-A (5.0L) must be obtained prior to installation of the replacement synchronizer assembly. Failure to follow this...
View ArticleAudi A4 Sedan 2002-2004, Audi A4 Avant 2002-2004, Audi A4 Cabriolet 2003-2004...
Check the following wire connection for open circuit according to wiring diagram:Relay carrier in E-box, plenum chamber, position 3Terminal Harness connector atignition coils Terminal 8 1 Specified...
View Article1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation
download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to...
View Article2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View Article2004 Hyundai Sonata 2003-2004 Hyundai Santa FE 2004 Kia Optima no spark...
download 1. At the crank position sensor, check for battery voltage to be present on the Red wire with the key on and cranking. The Black wire should be a good ground and the Blue wire should have 5...
View Article2003-2006 Chevrolet Express Antilock Brake (ABS) Activation At Low Speeds...
download Condition Some customers may comment on ABS activation at low speeds, usually below 8 km/h (5 mph). Upon investigation, the technician will find no DTCs set. Cause The cause of this condition...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article2006 Dodge RAM 1500 P2122-ACCELERATOR PEDAL POSITION SENSOR
download brake pedal is pressed or has failed. Acceleration rate and Engine output are limited. One trip fault and the code will set within 5 seconds . ETC light is flashing. POSSIBLE CAUSES (F855)...
View Article
